"CC" > wrote in message
...
> The hinge pin on my mixer started migrating out of place while using
> it.
> I had to keep watching the pin as the mixer ran to make sure it
> didn't fall out
> and the head fell off the stand.
> After thinking of all the ways I might repair this, tape over the
> pin to tighten it,
> etc, I finally found the solution after much goggle searching,
> There is a screw that holds the pin in, but, it's under the mixer,
> not the adjustment
> pin for the mixer height,
> Turn the mixer over on it's side, be careful of damaging the control
> knobs. and way
> up inside of the base, you will see a small screw that holds the
> hinge pin in place,
> Just tighten the screw and that will take care of the problem
> Hope this will help someone else
> CC

I don't know why I didn't just look under the mixer to begin with, I
would have seen
the screw and hinge pin, I guess the weight of it and never seeing one
with a set screw
holding it in before is the reason.
CC