In article >,
says...
>
> "blake murphy" > wrote in message
> ...
> > On Thu, 07 Oct 2010 16:25:25 -0500, Andy wrote:
> >
> >> Janet Wilder > wrote:
> >>
> >>> On 10/7/2010 12:57 PM, Andy wrote:
> >>>> Janet > wrote:
> >>>>
> >>>>> On 10/7/2010 2:35 AM, Andy wrote:
> >>>>>
> >>>>>> Give me the stamped FCCid# marked somewhere on the product and I'll
> >>>>>> get you the manual.
> >>>>>
> >>>>> The only thing stamped into the plastic is "9007W"
> >>>>
> >>>>
> >>>> 9007W is not an FCC ID.
> >>>>
> >>>> http://www.fcc.gov/oet/ea/fccid/
> >>>>
> >>>> Andy
> >>>
> >>> There are no other codes on the unit.
> >>
> >> Janet,
> >>
> >> If it's plugged in, or has a battery in it, it should have an FCC ID.
> >>
> >> Best,
> >>
> >> Andy
> >
> > the federal communications commission covers food processors now? is that
> > because food processors beam messages into your head?
>
> Electric motors generate interference with radio waves therefore the FCC has
> to approve of a design so as not to cause undue disruption to the airwaves..
> You could do a Google search before you spout off. It would make you seem
> less like a hostile and bitter loser.

ROF,L. If you had bothered with a google search you would have found
that (a) all approved devices do not have FCC IDs and that (b) electric
motors are classified by the FCC as "incidental radiators" and subject
only to the requirements that "Manufacturers of these devices shall
employ good engineering practices to minimize the risk of harmful
interference" (49CFR15.13) and that users of the device can be required
to quit using it if that use is causing harmful interference (49CFR15.5)

Further, FCC does not in general review designs, they require that
samples of the completed device be tested.

As an exercise, please since you are so certain that everything with a
motor has an FCC ID, go down to Home Depot and write down the FCC IDs
for all the power tools on display.